Linhong Walls Facory

How to Deal with Uneven Surface of Light Weight Wall Panel?

  • Feb 25, 2016

Some surface of light weight partition wall panel has obvious uneven phenomenon, especially in the joint portion of the two plates. The reason why is that the parts of the two plate joints have obvious uneven surface. At full batch in the wall, batch embedded layer of board is thicker, but batch embedded of seams is thin, when drying putty will shrink, which would cause the walls appear uneven phenomenon.

In order to ensure smooth walls, in the construction process, we should wait for the full batch wall layer is dried, then polish and sweep floating dust, on the wall to find the flat, until the whole wall is smooth, light weight partition wall panel can be carried out wall decoration.

Check the wall is smooth, it can be used a long ruler, if the two plates differ by more than 2mm, then it is not flat, we need rectification for it.

Light Weight Partition Wall Panel

Sales Center: 17th Floor, Gelan Building, Xisanzhuang Street, Shijiazhuang, Hebei, China
Copyrights © Hebei Linhong Technology Co., Ltd. All Rights Reserved       Technical Support: Reanod

Top
Linhong Walls Facory

How to Deal with Uneven Surface of Light Weight Wall Panel?

  • Jan 01, 1970

Some surface of light weight partition wall panel has obvious uneven phenomenon, especially in the joint portion of the two plates. The reason why is that the parts of the two plate joints have obvious uneven surface. At full batch in the wall, batch embedded layer of board is thicker, but batch embedded of seams is thin, when drying putty will shrink, which would cause the walls appear uneven phenomenon.

In order to ensure smooth walls, in the construction process, we should wait for the full batch wall layer is dried, then polish and sweep floating dust, on the wall to find the flat, until the whole wall is smooth, light weight partition wall panel can be carried out wall decoration.

Check the wall is smooth, it can be used a long ruler, if the two plates differ by more than 2mm, then it is not flat, we need rectification for it.

Light Weight Partition Wall Panel

Sales Center.: 17th Floor, Gelan Building, Xisanzhuang Street, Shijiazhuang, Hebei,China
Copyrights © Hebei Linhong Technology Co., Ltd. All Rights Reserved
Technical Support: Reanod

  • Links: solar charge controller piso flotante Clay Brick Machine Concrete 3D Panels steel bar cutting machine solar system battery Outdoor LED Panel glow in the dark power
  • Linhong Walls Facory

    How to Deal with Uneven Surface of Light Weight Wall Panel?

    • Jan 01, 1970

    Some surface of light weight partition wall panel has obvious uneven phenomenon, especially in the joint portion of the two plates. The reason why is that the parts of the two plate joints have obvious uneven surface. At full batch in the wall, batch embedded layer of board is thicker, but batch embedded of seams is thin, when drying putty will shrink, which would cause the walls appear uneven phenomenon.

    In order to ensure smooth walls, in the construction process, we should wait for the full batch wall layer is dried, then polish and sweep floating dust, on the wall to find the flat, until the whole wall is smooth, light weight partition wall panel can be carried out wall decoration.

    Check the wall is smooth, it can be used a long ruler, if the two plates differ by more than 2mm, then it is not flat, we need rectification for it.

    Light Weight Partition Wall Panel

    Copyrights © Hebei Linhong Technology Co., Ltd.
    All Rights Reserved
    Technical Support: Reanod